Carbon Tube
Carbon fiber tube for juggling staffs, cut to your length. Up to 2x stiffer than 7075 aluminium, 45% lighter. Classic, extra stiff or high temp, 16 to 22 mm.
Up to 2 times stiffer than 7075 aluminium and 45% lighter at the same size: our carbon fiber tubes are custom made for juggling staffs. No bend, no bounce, and so light that plenty of spinners used to classic staffs actually find them too light at first. It's the material advanced spinners move to, once lightness becomes an absolute priority. And we sell it for cheaper than anywhere else!
Carbon fiber is made of carbon filaments wrapped in layers and bonded with resin. It all comes down to how those layers are laid: on our tubes, most of the fibers run along the axis, backed up by a few layers at 90°, for maximum stiffness.
That said, carbon and fire don't get along: the resin softens and burns, and a carbon fiber tube can then break quickly. A carbon fire staff is still possible, but only if you rigorously protect every part exposed to heat, including with our high temperature carbon (180 °C / 356 °F is far below the temperature of a burning wick). For a fire staff that's simple to build, our 7075 aluminium tube is a better fit.
Working with carbon
When cutting, sanding or drilling carbon, always wear a dust mask (FFP2 minimum, N95 equivalent), safety glasses and gloves. Avoid breathing in carbon dust and keep it off your skin.
Only use suitable tools (fine saw blades, appropriate drill bits, low feed force) to limit splintering and cracks.
For a clean cut, wrap masking tape around the cutting area and rotate the tube as you saw. Then lightly sand the end.
For gluing onto carbon, epoxy works great, as long as you lightly sand the glossy surface first.
Safety and durability
Carbon breaks, it doesn't bend. Where an aluminium tube bends and gives you a warning, a carbon tube can crack on a sharp impact (a curb edge, a concrete floor) and fail later with no visible sign. After a hard drop, check for cracks, whitened areas or lifting fibers, and replace the tube if in any doubt.
Don't crush it. Carbon is very stiff in bending, but much less tough when squeezed: avoid overtightened clamps, overforced screws and cross drilling in areas under load. A dowel or insert inside the tube helps a lot.
To order, enter the exact length in centimetres. E.g.: 90 cm for a double staff, 150 cm for a contact staff.
Carbon Type
Classic carbon fiber tube
: about 70% stiffer than 7075 aluminium at the same size, plenty for most staffs. Available in 16, 19 and 22 mm.Extra stiff carbon fiber tube
: a special higher modulus fiber, about 2 times stiffer than 7075 aluminium. Available in 16, 19 and 22 mm.High temperature carbon
: a special resin stable up to 180 °C (356 °F), for projects where the tube heats up. Always with rigorous protection of the carbon. Available in 19 mm.Tube Size
16 mm OD (5/8") × 1.5 mm wall
, for double staffs, swords and hybrid staffs. About 106 gr per metre, so 127 gr for 120 cm. Max length: 120 cm.19 mm OD (3/4") × 1.5 mm wall
, for contact staffs and spinning staffs. About 128 gr per metre, so 204 gr for 160 cm. Max length: 160 cm.22 mm OD (7/8") × 1.5 mm wall
, for dragon staffs, long contact staffs and props where you want maximum stiffness. About 150 gr per metre, so 240 gr for 160 cm. Max length: 160 cm.Wholesale Pricing
We offer wholesale pricing on materials. Get in touch and we'll work something out.
Any question? Contact us at jugglingcalling@gmail.com
Prix : 25,00 €